What should I do if the oil press breaks into pieces? The slag from the oil press is flaked. Generally, the yuan discharge pressure wire of the oil press is not compressed, or the yuan discharge is seriously worn, resulting in flakes at the oil hole wear. When operating the machine, pay attention to the use force to avoid bad or over mature pressed oil, obvious decline in output, and slag leakage in the strip row and 2-5 yuan after the strip row, indicating that the accessories need to be replaced.
If the oil plasticity is poor and it is difficult to produce the cake, the pressure in the press chamber of the oil press will increase, which is also easy to produce slag. For the oil that is not well pressed, the moisture can be appropriately increased and the temperature of the press can be increased to increase its plasticity. Generally speaking, when pressing oil, pre-treatment such as frying and screening will be carried out to change the moisture and temperature of oil, so as to achieve appropriate conditions and press oil.
Precautions for screw press manufacturer:
1. Operators shall read the instructions carefully before operation.
2. Foreign matters are not allowed to enter the press hall, hand and hard objects are not allowed to enter the hopper to transfer materials, and cake discharging is not allowed.
3. When adjusting the thickness of the cake, do not act too hard, so as to prevent the tip and end from contacting the cake ring, causing the machine to jam or damage parts.
4. When the machine is working, operators are strictly prohibited from leaving the site.
5. When the machine is running, do not approach the leaking running parts to avoid safety accidents.
6. Special attention: when the bearing inside the screw head of the spindle assembly is stuck, it will cause the screw head to rotate, and the adjusting handle will hurt people. Therefore, people should leave the screw head handle when the machine is running to avoid accidents.
