What are the details that should be paid attention to when pressing oil by full-automatic oil press? Our company has summarized some for you and hopes to help you:
1、 Remove the oil edge of the sieve. During inspection, if the screen surface is not horizontal, adjust the length of the left and right arms to be equal. If the screen is twisted, the eccentric shaft can be adjusted to be perpendicular to the frame. If the oil on the surface of the stone mesh is single-sided, the level of the frame can be adjusted; If the air flow is uneven, the adjusting plate of the frame can be adjusted to evenly blow the air flow to the screen. If the unclean rate of the network is low, replace the brush or adjust the length of the brush and adjust the inclination angle of the plane.
2、 The main reason why the belt oil can not be lifted is that there is too much oil accumulation at the lower part of the bucket elevator conveyor, resulting in blockage. You can open the plate door at the lower part of the conveyor to clean up the oil accumulation.
3、 The steaming material in the pot is uneven. When the steam nozzle of the steam dryer is blocked or rusted during inspection, please dredge the steam nozzle. If there is a blank bottom of the oil tank in the middle, the distance between the scraper and the bottom of the oil tank can be adjusted, and the scraper is twisted and worn. When the blank of the scraper must be replaced, and the steaming and frying is uneven, please adjust the limit switch, contact and floating plate to make their actions coordinated.
4、 The drum is overloaded and does not rotate. The troubleshooting methods are as follows: when starting, there is oil between the rollers, loosen the adjusting bolts between the rollers and remove the oil between the rollers; If the feeding amount is too large and the speed is too fast, the plate at the feeding port can be closed. If the thickness of the roll blank is uneven, readjust the gap of the roll blank, tighten and loosen the nut.
The quality of automatic oil press depends on the oil output. There are many factors that determine the technical setting of oil production. The pressure and temperature of the pressure chamber are the main factors affecting the performance of the full-automatic oil press. The full-automatic oil press adopts circulating line, oil line clearance of 150 wires, large amount of slag, reduce the pressure of the pressure chamber, reduce the oil output, and ensure the pressure and yield of the pressure chamber. Electronic temperature control technology is adopted to ensure the appropriate oil outlet temperature of the pressure chamber and timely control the pressure and temperature required by different oils.
