When using the full-automatic oil press, you must pay attention to the maintenance problem, because I think getting along with the full-automatic oil press equipment is like getting along with people. As long as you focus on it and make good use of it, it will extract oil for you and let you use it for a few more years. This is the maintenance method I summarized.
Each lubricating part shall be protected from dust and other impurities. The quality of reduction oil shall be checked every year. If deterioration is found, all oil shall be replaced. After 50 hours of operation each time, check the lubrication. The deceleration oil cup shall not be short of oil. The adjustment screw inner bearing shall be supplemented with grease once a shift from the adjustment screw hole. Dry grinding is strictly prohibited.
This is also very important. Don't be reluctant to stop the equipment for inspection in order to squeeze more oil. This will cost you more than stopping for inspection.
When the pressing amount is reduced and the cake or oil output is abnormal, pull out the pressing screw, check whether the pressing screw, pressing strip and cake ring are worn, and replace the worn parts. After each completion, be sure to remove the residues inside the machine and clean the dust and oil dirt on the surface of the machine. If it is not used for the time being, the machine can be maintained first, then the screw pressing, strip pressing and cake ring can be removed and washed, re oiled and used after the machine is dry.
The fully automatic oil press is also a living thing and a thing that knows how to be grateful, so we should pay more attention to their feelings when using it! Repair is an important step of the machine. I hope those who help the machine can repair the machine correctly to avoid losses.
